A As shown in Figure A, the two wheel sets come with looped clips that snap into the unit. Fig. B Fig. C WÊÊkW V I jQ Figure B displays the back of the unit where the wheel sets are set in place, directly over the screw holes on the unit. As shown in Figure C, you must align the looped clips in the open slots bordering the hole set on the unit. The wheel sets should then click in place as shown in Figure C as well. NOTE: The supported block side of the wheel sets aligns with
• Don’t lift or move by pushing the unit at the rear, but always at the side. GB 3 GB • Never operate this appliance if it has a damaged cord or plug. Do not lead the cord over sharp edges. • A damaged supply cord should be replaced by the manufacturer, its service agent or a qualified person in order to avoid a hazard. • Any service other than regular cleaning or filter replacement should be performed by an authorized service representative. Failure to do so could result in a loss of warranty.
We wish you many years of enjoyable use. After reading this manual, please keep it in a safe place for future reference. Read this entire instruction manual before use. Please keep your receipt. Your receipt is your Proof of Purchase and is necessary for warranty service. Specifications Model AMH9 Turbo Convector heater with thermostat and fan Maximum Power 1500W Power Range: 750W-1500W Motor Power: 20W Voltage: 120V~ / 60Hz 2 Assembly Before using the heater, attach the feet (included separatel
• Read all instructions before using this heater. • This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. • Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear. • Extreme caution is necessary when any heater is used by or near children or handicapped persons. • This heater is equipped with a grounded type plug (see illustratio
Warning: This appliance must be earthed. This appliance operates from a 3 pin 13 amp plug. The voltage rating is 230 volts and should be protected by a 13 amp fuse either in the plug or distribution board. The appliance is supplied with a moulded 13 amp 3 pin mains plug fitted with a 13 amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 amp and approved to BS1362. The plug contains a removable fuse cover that must be refitted when the fuse is replaced. In
60% maintains the relative humidity around 60% for personal comfort. 70% maintains the relative humidity around 70% in the room. 80% maintains the relative humidity around 80% in most cases the compressor will be OFF. To set the desired relative humidity level press the or button repeatedly. Setting the fan speed. Push the SPEED BUTTON to change the fan speed, the chosen speed will be indicated on the LCD, for the high speed and for the low speed. Setting the Timer The timer switches the unit on
Bacteria carried by the air are being killed by the TiO2 filter. STORAGE If the dehumidifier is not used for long periods of time, follow these steps: • disconnect the unit and wrap the power cable. • if used, empty the water container, remove the scent emitter . • clean the unit and filter, pack it in its original packaging or cover to protect against dust. • store the unit in an upright position in a cool, dry place away from access by children. 11 12 GB When the water tank is full, the unit w