Of course, other sections of the extrusion line also influence the quality of the extruded product. This section does not provide solutions to problems originating with other equipment on the extrusion line. Additional troubleshooting help can be found in the manufacturer’s manuals included with this User Guide. UGE058/0803 CTS Saw TROUBLESHOOTING 6-3 ELECTRICAL PROBLEMS Symptom Saw will not start Saw blade runs backwards Look in this section when you have problems such as lights on the contro

Open pneumatic and electrical enclosures and remove the dust and chips from all components. . ..Check that the FRL (filter-regulator-lubricator) for the air input is filled with oil and that the oilier is working. Pressure should be set for around 60 PSI. This unit also has an automatic drain for any moisture that may develop. The bowl should be kept clean to ensure it will operate properly. Quarterly . .. Blow or vacuum, dust and chips from the inside the saw. Remove all dust and chips from in

3 Remove the hex nut. The blade is held on with a hex nut tightened on the motor arbor shaft. Based on either right to left or left to right saw operation, the hex nut will be either a left hand or right hand thread. A right to left saw operation means that the product is entering the saw from the right side. A right to left operating saw will use a left-handed threaded arbor. This is done to insure that the arbor nut will want to continually tighten during blade rotation. The motor has an arrow