When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery. If you continue to use the tool and exhaust the electric current, the battery may be damaged and its life will become shorter. . Avoid recharging at high temperatures. A rechargeable battery will be hot immediately after use. If such a battery is recharged immediately after use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery and recha

15 Wing Bolt, Lock spring Base Guide Fig. 16 (Rip Fence) . Never operate the circular saw with the saw blade turned upward or to the side. . Do not fix and secure the switch lock. Besides, keep your finger off the switch trigger when the circular saw is being carried around. Otherwise, the main body switch can be inadvertently turned ON, resulting in unexpected accidents. . Keep the light ON during cutting operation only. If it is lit ON in other cases, the main body switch can be inadvertently

Power tools are dangerous in the hands of untrained users. e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power t

Check that the miter scale and the tip of the indicator are properly aligned. * Operation of the saw with the miter scale and indi- Indicator cator out of alignment, or with the side handle not properly tightened, will result in poor cutting preci- Side Handle sion. English 7. Bevel cutting procedures (1) Loosen the clamp lever and bevel the saw blade to the left or to the right. When tilting the motor head to the right pull the fixing pin towards the rear. Bevel Angle Scale (2) Adjust the bevel

If the machine is fed too fast, it could cause the blade to break. 3. Cutting a circle or a circular arc The guide also will be helpful for circular cutting. After attaching the guide by same way noted as above, drive the nail or screw into the material through the hole on the guide, then use it for a axis when cutting. (Fig. 14) NOTE: Circular cutting must be done with the blade approximately vertical to the bottom surface of the base. Allen wrench Fig. 11 Base Base bolt Fig. 12 Base Fig. 13 M5

6. NEVER FORCE THE TOOL. It will do the job better and more safely if it is operated at the rate for which it was designed. 7. ALWAYS USE THE RIGHT TOOLS. Never force a tool or an attachment to do a job for which it was not designed. 8. ALWAYS WEAR PROPER APPAREL WHEN WORKING WITH THE TOOL. Never wear loose clothing, gloves, neckties, rings, bracelets or other jewelry which may get caught in the moving parts. Always wear non-slip footwear, preferably with steel toes. Wear protective hair coverin

30. OPERATE POWER TOOLS AT THE RATED VOLTAGE. Operate the power tool at voltages specified on their nameplates. If using the power tool at a higher voltage than the rated voltage, it will result in abnormally fast motor revolution and may damage the unit and burn out the motor. 31. NEVER USE A TOOL WHICH IS DEFECTIVE OR OPERATING ABNORMALLY If the tool appears to be operating unusually, making abnormal noises, or otherwise appears defective, stop using it immediately and arrange for repairs by a

12 Aligning the blade direction with the grain of the wood, cut step by step until a window hole is cut in the center of the lumber. (Fig. 12) (2) In other materials When cutting a window hole in materials other than lumber, initially bore a hole with a drill or similar tool from which to start cutting. 6. Angular cuttingThe base can be swiveled to both sides by up to Base 45° for angular cutting. (Fig. 13) (1) Loosen the base bolt by allen wrench attached on base and move the base fully forward