If your spray hose is installed on same water line as the dishwasher, we suggest you disconnect the sink spray attachment and plug the hole. Avoid fire hazard or electrical shock. Do not use an adapter plug, extension cord or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death. Electrical Connection for a Portable/ Convertible Dishwasher An electrical supply of 120 volts, 60 Hz, AC only, 15 amps is required. For your safety, t

Reconnect the water, drain, and electrical power supply. 2. Turn on water and electrical power supply. 3. Fill both detergent cups and run dishwasher through a NORMAL cycle. 4. Check connections to make sure they do not leak. Note: See Installation Instructions for more details. 11 Connecting and Disconnecting the Portable/ Convertible Dishwasher The portable/convertible dishwasher must be connected to a faucet and electrical outlet each time it is used. Follow directions on this page to properl

NOTE: Install Top Mount Clips before unit is installed into the cabinet. Insert the installation brackets to the front top slots of the dishwasher. (See image below) To install the Side Mounting Clips. Depending on space allowed in cabinet the Side Mounting Clips can be installed with the holes for the screw up (preferred method) or down as shown in the illustrations below. NOTE: Install Side Mount Brackets before unit is installed into the cabinet. Insert the installation brackets to the side s

At first fill, approximately 1 minute make sure water completely covers filter surface. . At pump-out: (pump-out is either when the cycle is completed or canceled. refer to the Use and Care Manual for Start/Cancel), make sure all water is pumped out. Check water connections again for leaks. Electric Shock Hazard If all connections are correct, there are no leaks, and unit runs properly, replace the kickplate assembly before placing unit into operation. Failure to follow this warning could result

• Adjust the amount of detergent based on the water hardness. (Check Detergent Chart.) • Lower the water temperature. • Use the No Heat Dry option. Detergent Left in Cups •Detergent may be old. Discard and use fresh detergent. •Be sure water action can reach the dispenser. •Check to see if cycle has been completed. •Make sure items do not prevent the detergent dispenser from opening. Dishwasher Leaks •Use only fresh detergent designed for automatic dishwashers. Measure detergent carefully. Try a

• DO NOT USE detergent. • Turn dial to RINSE/HOLD. • Select HI-TEMP RINSE OFF and HEAT DRY OFF. gal. imp. gal. liters 1.2 1.0 4.5 12 min. 1 rinse 750 Series Energy Options Hi-Temp Wash Option When HI-TEMP WASH ON option is selected, the dishwasher heats the water in the main wash to approximately 140°F (60°C). Wash action will continue but timer will not advance until proper temperature is reached.The hotter water provided by this option helps activate dishwasher detergent to clean food grease a

2 Features.............................. 3 Normal Operating Sounds ............................. 4,6 Operating Instructions ...................... 4-7 Preparing and Loading Dishes ............... 8-9 Dishwasher Dispenser and Detergents ..............10-11 Factors Affecting Performance ...................... 11 Care and Cleaning ............................ 12 Solutions to Common Dishwashing Problems...13-15 Consumer Services Warranty & Service .......................... 16,17 Version en espanol

All of the provisions of the full warranties above and the exclusions listed below apply. Costs of the technician's travel to the home and any costs for pick up and delivery of the appliance required because of service. In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc. We authorize no person to change or add to any of our obligations under this warranty. Our obligations for service and parts under this warranty

If water remains in the bottom of the tub, dishwasher may not be draining properly. (See Dishwasher Does Not Drain Properly.) Vapor at Vent • Water vapor escapes from the vent when the dishwasher goes into the drying part of cycle. This is normal. Dishwasher Won’t Run • Check to see if circuit breaker is tripped or if a fuse is blown. • Make sure water supply is turned on. • Check to see if cycle is set correctly. (See Operating Instructions.) • Is dishwasher set for delay start option? • Make s

Make sure tall items do not block spray arm rotation. Place plates and platters so that they do not touch. Place bowls, casseroles and sauce pans with the soiled surface facing down or toward the center. Tilt slightly for better drainage. Be sure pan handles do not protrude through the bottom of the rack and block the spray arm rotation. Dishwasher Dispenser & Detergents • Use only fresh automatic dishwashing detergent. Other types will cause oversudsing. • Add detergent just before starting cyc