Introduction ....................................................................................................2 B. Service Information ........................................................................................3 C. Special Safety Information ............................................................................3 II. SAFETY AND WARNINGS A. Safety Decals (Labels) ....................................................................................4 B. General Safety Rules ....

All specifications, illustrations and directions in this SERVICE DATA are based on the latest products information available at the time of publication. ECHO SERVICE MANUAL Ord. 403-11 (Model : PB-2100, PB-2110, ES-2100, ES2400) contains lots of information for servicing this model. INDEX CONTENTS page 1 SERVICE INFORMATION ............................. 2 1-1 Specification ............................................... 2 1-2 Technical data ............................................ 3 1-3 Torq

32.13 (1.265) C Piston pin bore Max. 8.030 (0.3161) D Piston ring groove Max. 1.6 (0.063) E Piston ring side clearance Max. 0.1 (0.004) F Piston pin outer diameter Min. 7.970 (0.3138) G Piston ring width Min. 1.45 (0.057) H Piston ring end gap Max. 0.5 (0.02) K Crankshaft runout Max. 0.05 (0.002) A B C D F G H K E PB-2100 PB-2155 SERVICE INFORMATION PB-2200SI 1-6 Special tools 1 2 3 4 5 a = 3 mm a = 4 mm 6 7 8 9 10 11 12 13 14 2020 4040 6060 8080 120120 140140 160160 180180 2020 10010015 Key Par

That is, a vocal few have done everything they can to control and in some cases ban the leaf blower. The stated reason is noise! Landscapers respond that they would not be able to remain in the lawn care business without a leaf blower, because it would take too long to do their final cleanup. Thus, profits would be severely impacted. The leaf blower has been in the spotlight, under the microscope so to speak, and has been singled out from all other forms of industrial equipment as being too loud

PB-2100 Type 1E S/N 001001 & Up Intake, Exhaust................................................................................................................................................................4 Carburetor........................................................................................................................................................................6 Ignition, Starter, Fuel System.................................................................................

Always loosen fuel caps slowly allowing pressure to equalize. • NEVER refuel a unit when the engine is HOT! • NEVER refuel a unit with the engine running. • DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground. • Securely tighten fuel cap after refueling. • Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired. After use • DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an ap

Engine exhaust contains poisonous emissions and can cause serious injury or death. • Review area to be cleared. Look for potential hazards such as stones or metal objects. • Spectators and fellow workers must be warned, and children and animals prevented from coming nearer than 15 m (50 ft.) while the blower is in use. • Take wind conditions into account: avoid open doors and windows. • Provide all operators of this equipment with the Operator's Manual and instructions for safe operation. •

During the break-in period your engine performance will increase and exhaust emissions will stabilize. Idle speed can be adjusted as required. High Altitude Adjustment High altitude adjustment may be required for proper operation of this engine. IMPORTANT For engine operation above 2,000 feet, turn the high-speed needle lean (CW) until the engine runs between 7,000 and 8,000 RPM. Then turn the low-speed needle lean (CW) until the engine does not hesitate on acceleration. For engine operation bel

8. Install the spark plug (do not connect ignition cable). 9. Remove blower pipe assembly from unit. SERVICING INFORMATION SERVICING INFORMATION Genuine ECHO Parts and ECHO Re Power Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number, Type number and Serial Number of the unit with you. You can find all three numbers on the engine housing. For future reference, write them in the space provided be