valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
3 Power off the library
6 Remove the Interface Manager card
Use your backup software or the Operator Control Panel (OCP) to empty
the picker or to verify that the picker is empty. Stop al library activity.
Set the library power switch at the upper right corner to the OFF
position. Make sure that al power indicators on the power supplies
are off.
10541a
4 Identify the Interface Manager card
Use a #1 Phillips screwdriver to loosen the captive screws in the black
ejector handles at the ends of the Interface Manager card. Push the
ejector handles to the outside, then pul on them to remove the control er.
CAUTION:
Be aware that the metal tabs on the gasket on the filler panel can
be caught and bent by the pins on the Interface Manager card.
If bent, these tabs can cause a short circuit. Avoid removing or
installing the Interface Manager card at an angle and watch that
the metal tabs on the gasket do not get caught or bent.
7 Move the CompactFlash card
The Interface Manager card contains a CompactFlash card which stores
the library configuration. To retain the library configuration, move the
CompactFlash card to the replacement Interface Management card.
10539
The Interface Manager card is located in the bottom slot of the base
module card cage.
5 Label and unplug the cables
10032a
Grasp the edges of the CompactFlash card and slide it out of the slot
on the original Interface Manager card. If needed, push a pen into the
corner notches of the slot to unseat the CompactFlash card.
Remove the replacement Interface Manager card from its protective
sleeve and place it on your work surface.
11800a
Label the cables or write a note that shows the locations of all the cables
plugged into the Interface Manager card to make it easier to reconnect
them later. Unplug all cables from the Interface Manager card.
10033a
With the connector going in first, align the sides of the CompactFlash
card with the slot on the replacement Interface Manager card. Gently
slide the CompactFlash card into the slot until it is securely seated.
Page 2
... Questo manuale è adatto anche per i modelli :
dati dispositivi di elaborazione - HP EML 103e Tape Library (709.9 kb)
dati dispositivi di elaborazione - HP EML 245e Tape Library (709.9 kb)
dati dispositivi di elaborazione - HP EML Base Library (709.9 kb)
dati dispositivi di elaborazione - HP EML E-Series 103e Base Tape Library (709.9 kb)