valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
10
11
TO FIBRE CHANNEL CONTROLLERS
NETWORK
SERIAL
AUX
STATUS
Power on the library.
a. Set the library power switch at the upper
ERROR
right corner to the ON position.
b. Check the power supply power indicators
to verify that the power is on.
c. Verify that the library robotics controller
Active indicator is lit.
Verify that the status LEDs of the Interface
Manager card indicate a normal state. For a
description of LED diagnostic codes, refer to the
Troubleshooting chapter of the HP StorageWorks
Interface Manager and Command View for
Tape Libraries Software user guide.
Updating Firmware
12
After replacing the CompactFlash card, you must update the Interface Manager card
firmware and reconfigure the Interface Manager settings. To operate with the EML
E-Series tape library, the Interface Manager card must have firmware version I155
or later.
To update firmware:
f. If necessary, use the ls command to list the
1. Acquire the latest firmware file from:
contents of the ftp directory.
http://www.hp.com/support/cvtl
g. Enter the following command to turn on binary
2. If necessary, transfer the firmware file to a client PC
transfer mode: bin
or laptop that will be used in step 3 to connect to
h
the Interface Manager card.
. Enter the following command to copy the
firmware file to the temporary location in the
3. Use ftp to transfer the firmware file to a temporary
Interface Manager card’s memory:
storage area in the Interface Manager card’s
put
memory.
where
a. If connected, disconnect the Ethernet cable from
firmware file.
the Network port on the Interface Manager
i
card.
. Use the quit command to logoff the ftp session.
b. Connect a host PC or laptop to the Cascade
4. Start a Telnet session on the PC or laptop that is
port of the Interface Manager card using an
connected to the Interface Manager card via the
Ethernet cable.
Cascade port:
c. On the host PC or laptop, open a command
a. From a command prompt, enter the following:
shell and navigate to the directory that the
telnet 192.168.2.1
firmware you downloaded in step 1 is located.
b. At the login prompt, enter the following
d. Enter the following command: ftp
information:
192.168.2.1
— Username: cliadmin
e. Login with the following credentials:
— Password: clipwd
— User name: ftp
5. Enter the following command to update the
— Password: Use your e-mail address
firmware:
download mgmt
...
dati dispositivi di elaborazione - HP EML 103e Tape Library (1.4 mb)
dati dispositivi di elaborazione - HP EML 245e Tape Library (1.4 mb)
dati dispositivi di elaborazione - HP EML Base Library (1.4 mb)
dati dispositivi di elaborazione - HP EML E-Series 103e Base Tape Library (1.4 mb)