First Time Installation: 2.0 General Settings Plug in your Set Top Box. The “Easy Installation” menu is shown. Select the desired language with cursors and Check all settings are as you want-all settings will change to the most used setup For the chosen OSD language. Once you have correctly connected the Set Top Box. You are ready to perform the “Easy Installation” During this procedure helpful information is displayed at the bottom of the menus to guide you through all the steps t

CA-module and smart card....................................................................6 Rear panel........................................................................................................................6 Inserting batteries in remote control unit ..........................................................................7 The remote control unit ....................................................................................................8 How to use the remote control

• When you have found a UHF channel without interference, do not forget to store it on your TV. The satellite receiver automatically stores the new setting when you press the [menu] button on the remote control. • Disconnect the satellite receiver from the mains. REMEMBER: Please note that a later resetting to factory settings always resets the satellite receiver to the original UHF channel setting on channel 38. We therefore recommend that you make a note of the UHF channel that you change your

5 Overview ............................................................................................................................. 6 Front panel incl. CA-module and smart card .................................................................... 6 Rear panel ........................................................................................................................ 6 Inserting batteries in remote control unit ......................................................................

• Use “Default Value” function to restore all channels in the “Tools” menu. 3.6 Restore channel list and settings To restore channel list and settings. 1. Enter the password. The default password is “0000”. 2. After entering the password correct a safety question will show up where you have to confirm first. 3. Select “Yes”, press [OK] to restore the last backup channel list, the current channel list will be erased. Select “No” press [OK] to cancel the operation. 17 Menu Operations 3.7 Save chan

Each time you press the TUNER button, the tuner will be changed. 4. Main Menu Guide 4.1 PVR - Record & Play 4.1.1 Record With this function, you can check file information while recording with the PVR. In addition, you can set the record-end time, and the power to go off after recording. • Press the UP/DOWN button on the PVR menu to select Record and then press the OK button. • When you press the OK button on the Record screen, the Edit screen will appear. • Press the UP/DOWN button on the Edit

1 Switch on TV and the set-top box 2 Welcome Follow the instructions displayed on the TV screen. 3 Select the language and country 4 Data for channel searching In case your CATV operator has provided you with a USB stick, place the stick in the USB socket at the rear of the set-top box. Press the OK key to start the channel search. The information that the USB stick contains is used in connection with the channel search. 3 Note Even if you do not use a USB stick you have to press the OK key to s

output voltage dBMV 108 108 Supply voltage V 5-24 5-24 Power consumption mA 50 50 Dimensions length mm 325 325 width mm 255 255 height mm 65 65 Connector F-connectors F-connectors Included Mast bracket 025-60 Mast bracket 025-60 Plastic base Plastic base Universal mount Centre mount Mast bracket Plastic base Universal mount Centre mount 025-60 Art. No. 133220 Art. No. 133222 Art. No. 133225 Art. No. 133223 Accessories IFP 502 Power supply Art. No. 339502 IFP 529 Power inserter

Position the antenna and mark off holes for fixing. Positioned antenna and counter nut fixed. Mounting with universal mount (UFO 120 digital) GB N ^TRIAX GB Troubleshooting guide Problem Possible root cause Solution Weak or missing signal -check LED on power supply (PSU) NO light indicates no voltage. Often this is coursed by a short or a missing connection in the coax-cable or the cable connectors Remove the cable from the PSU, if the LED goes ON, there is a short in the cable. Then re