Box 1520, Sykesville, MD 21784-1520 Tel: (410) 549-6083 / Fax: (410) 549-6082 Models: AC-4000 and AC-6000 TABLE OF CONTENTS WELCOME Safety First................................................................................................................................................ 3 INSTALLATION General..................................................................................................................................................... 4 Cell.................................

3. Connect the Auto-Chlor Chlorine Generator to the Load 1 & 2 connectors of the Auxiliary Relay to control the generator’s operation. 4. Bonding is recommended and may be required by local code. The bonding lug is found on the bottom of the Control Box. 5. Set the chlorine generator to 100% power, and program the Aux Relay to run the chlorine generator as needed. (e.g. 100%, 50%, 25% of the time the pump is running). 240Volt Circulation Pump With 240 Volt Chlorine Generator 120Volt Circulation

3. On/Off Light is OFF: No power .. System is turned off. .. Turn Control Knob clockwise to the desired setting. .. Main fuse blew. .. Check main fuse on bottom of Control Box and replace if necessary with a 6.3 Amp 250VAC 6x32mm Slow Blow fuse. One extra fuse is supplied on the bottom-side of the Control Box cover. .. Breaker jumped .. Check the breaker leading to the pool control. .. Power wires cut, disconnected, or incorrectly wired. .. Check for correct wiring. .. Other malfunction in Contr

Check the Cell to ensure the blades are in good condition and not coated with calcium buildup. Cleaning the Cell is recommended if it is calcified or if the readout seems questionable. Before adding salt, it is advisable to have the salt level professionally checked. MAINTENANCE Maintaining your Auto-Chlor Chlorine Generator requires minimal work but will maximize the performance and life of the system. ..POOL WATER TESTING: Pool water should be tested weekly. Cell Maintenance Our clear Cell all

. WHAT TO DO IF YOU SMELL GAS . Do not try to light any appliance. . Do not touch any electrical switch; do not use any phone in your building. . Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. . If you cannot reach your gas supplier, call the fire department. . Installation and service must be performed by a qualified installer, service agency orthe gas supplier. . Do not store or use gasoline or other flammable vapors and liquids in the vicin

10. Reattach access panels to the opposite sides. For ASME Models call your factory representative. ACCESS PANEL Fig. #1 PRESS SWITCH AGS HI-LIMIT Fig. #2 18 JACO FITTING Fig. #3 BULB & CLIP Fig. #4 RE-INSTALLED IN/OUT HEADER ON OPPOSITE SIDE. Fig. #5 19 ELECTRICAL WIRING NOTE: If it is necessary to replace any of the original wiring, it must be replaced with 105° C wire or its equivalent, and /or 150° C wire or its equivalent as originally built. MILLIVOLT SYSTEM The Millivolt System residentia