Showerhead and/ or bracket stiff to change angle a Immerse pivot ball and large nut of the bracket in hot water or use a blow dryer for several minutes and then use a towel to loosen the large nut. For Fixed Mount: install FM shower head to provide additional leverage to change angle of spray. (Contact Waterpik for further assistance). Care and Cleaning Clean the filter screen at least once a year, or when you notice a drop in water pressure. To remove, unscrew the nut from the pipe. Remove the

Improper installation and/or operation could create carbon monoxide gas in flue gases which could cause serious injury, property damage, or death. Improper installation and/or operation will void the warranty. Installation and Operation Manual Laars Lite 2™ Pool and Spa Heater Models LG and LD Natural Gas or LP Gas NOTE: LD LP Gas For Outdoor Use Only AWARNING: If these instructions are not followed exactly, a fire or explosion may result, causing property damage, personal injury, or

Do not attach this product to a plastic shower arm since it may not provide adequate support. Tools are not required. Do not use pipe tape or any other sealants when installing the showerhead. These materials are not necessary and may cause the nut to loosen prematurely. Hand tightening is sufficient to secure the shower thread. Make sure the washer is in the end of the nut. Spray Change Button Guia de solucion de problemas Problema Solucion No hay flujo de agua proveniente del cabezal de ducha

Outdoor Installation Laars Lite 2 heaters can be installed in the low-profile, grate top configuration (U.S.A. only) as received from the factory, or with an optional high wind vent cap/stack. Canadian units require a factory approved vent cap. Figure 3. Outdoor Heater Installation. Locate the heater in an open, unroofed area. Do not install the heater under a deck. Do not locate the heater below or adjacent to any doors, glass openings, louvers, grills, etc., which connect in any way with an

b Confirm the hose is properly installed, try switching ends. c Confirm there is only one washer in the pivot ball. Low water pressure or missing spray patterns a Clean shower head in vinegar/water solution. (See care section). b Clean screen and flow regulator. Leaking at pipe pivot ball connection: a Confirm one single washer is seated on top of the screen. b Grate bar of soap across the j-pipe threads to act as a sealant. Showerhead and/ or bracket stiff to change angle a Immerse pivot ball a

Water Pik, Inc. is not responsible for labor charges, installation, or other consequential cost. The responsibility of Water Pik, Inc. shall not exceed the original purchase price of the product. This warranty gives you specific legal rights. You may also have other rights that vary where you reside. Save your receipt as proof of purchase is required for warranty action. Have any questions or need assistance? If in the U.S., call our toll-free Customer Assistance Line, 1-800-525-2774outside the

In the past, recommendations were often reserved for those individuals with special needs. Today, with the wide variety of products on the market, almost any individual can benefit from a power brush.1 A practice-based study that included 3,669 dental professionals and 16,903 subjects demonstrates how typical dental office patients can benefit from a power brush. In the study, power toothbrush use was considered by dental professionals to have a positive effect on the oral health of 80.5% of pat

Turn unit ON until water flows from the handle, turn unit OFF. Select and Insert Tip: [4 Press tip firmly into handle. When tip is properly inserted there should be no gap between control knob and handle. Adjust Pressure and Pause Control: For first time users, adjust pressure control to lowest position. Gradually increase pressure as you prefer. You can temporarily stop water flow by pressing the pause button on the handle. continued on back Using your Waterpik® Water Flosser: Always

3. Hand tighten pivot ball to pipe. 4. Hand tighten adaptor to showerhead. 5. Hand tighten hose to adapter and bracket. 6. Place showerhead in bracket. drenching rain showerhead Spray Change Button Shower Arm Nut Collar Models: CF-200 CF-201 CF-201C CF-203C CF-209C CF-261 CF-263C Flexible Arm Spray Change Button Bracket Adapter 5’ hose Instruction Manual Flow Control Waterpik® brand showerheads are equipped with an OptiFLOW® regulator that limits maximum water flow to 2.5 gallons per minute at 8

WELCOME WELCOME Congratulations! By selecting the Waterpik® Water Flosser you are now on your way to better gum health, and a healthier smile! With a clinically proven combination of water pressure and pulsations, the Waterpik® Water Flosser removes harmful bacteria deep between teeth and below the gumline – where brushing alone won’t reach. We are so convinced that you will be happy with your new Waterpik® Water Flosser, that we back it up with a 14-day guarantee. If you aren’t satisfied that y