35 SELF.CLEANING THE OVEN ..................................................................................................................................... 35 MAINTAINING YOUR RANGE.................................................................................................................................. 36 CLEANING YOUR RANGE ........................................................................................................................................ 36 TROUBLESHOOTING GUIDE

The amount of smoke stain is directly related to the amount of food residues in the oven cavity before the start of the self.cleaning cycle. Before Self Cleaning the Oven Wipe out large spillages, grease and any loose soil that can be easily removed. Remove any soil that is outside the door seal area. This appliance is designed to clean the oven interior and the portion of the door that faces the oven cavity. The outer edges of the door and the oven cavity are not in the cleaning zone. Wipe this

The minimum gas supply pressure for checking the regulator setting shall be at least 1“ w.c. (249 Pa) above the inlet specified manifold pressure to the appliance (this operating pressure is 4” w.c. (1.00 kPa) for Natural Gas and 11” w.c. (2.75 kPa for LP Gas). 9 INSTALLING THE LEGS INSTALLING THE WORKTOP Bertazzoni ranges must be used only with the legs properly installed. Four height.adjustable legs are shipped with the range in the polystyrene container situated over the appliance. Before ins

BAKEWARE TYPE Metal bake ware (with or without a non.stick finish), heat.proof glass, glass ceramic, pottery, or other utensils are suitable for the oven. Suitable cookie sheets have a small lip on one side only. Heavy sheets or those with lips on more than one side may affect the baking time. BAKE RACK POSITIONS Rack level positions in the oven are numbered as in the diagram on page 25. ONE RACK BAKING . The Bake mode is best for baking on one rack with rack level 3 and 4 used for most baked it

To convert the regulator for use with other liquid propane LP gas: 1. Unscrew by hand the upper cap of the regulator, remove the white plastic attachment from the cap, reverse its direction and screw it again firmly against the cap. The white plastic attachment has arrows indicating the position for natural gas (NAT) and LP gas (LP). 2. Screw by hand the metal cap in the original position on the regulator. 19 STEP 2: SURFACE BURNERS To replace the nozzles of the surface burners, lift up the burn