Rx Div) on the back of the Raven X. Use of receive diversity for EV-DO is optional. Data transmission and reception will not be adversely affected if it is not used. Connecting Power Your Raven X can be used with either DC (available in most automobiles) or 110 AC (standard US wall power) with the appropriate power adapter (available from AirLink). The power cable positive lead should be connected to the battery or power source positive terminal. The power cable negative lead should be connected

Otherwise, the print server will not be configured successfully. Please refer to your printer’s manual for instructions on how to install the printer driver. Before setting up the print server, please take note of your TCP/IP setting. Step 1 Click on Start, Run, and type command (for Windows 95/98/ME) or cmd (for Windows 2000/ XP) and click OK. Step 2 At the command prompt, type ipconfig and press Enter. Step 3 Write down the information for the IP Address, Subnet Mask, and Default Gateway. You

5-6 5.5 DSL Configuration .................................. 5-8 5.6 Configuration File ..................................5-11 5.1 Configuration The NetDSL Configuration walks you through the configuration of the NetDSL with a series of windows. You will be asked to enter information that you received from your ISP or network administrator – refer to Section 1.4, Information You Will Need for the configuration parameters for a Single IP Address Account or a Multiple IP Address Account, and other

-5 Step 7 Remove the Driver & Utility CD from your CD drive and then click OK to restart your computer. -6 Install the device Note: Make sure the procedures in “Install the Driver & Utility” have been performed. In most cases, Windows will automatically install the driver after the computer is restarted, if the Found New Hardware Wizard appears, follow the steps below. Note for Windows 98 & ME users: Before installing the device, make sure you have your Windows 98 or ME CD at hand. You may be as

•Outgoing Network Connection: Enables an outgoing connection to the specified host. •Outgoing Telnet Connection: Enables an outgoing telnet connection to the specified host. •Modem Service Options: When Modem Service is selected, you may also configure the Source TCP Port. In most cases, the value used for the source port is arbitrary and you can leave this field set to 0 for “any”. However, if your server or firewall has specific requirements you may specify an explicit source port number in th

1A 1 Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran

1.1 Table of Contents 1. Introduction................................................................................................................................. 3 1.1 Package Contents.................................................................................................................. 3 1.2 Features................................................................................................................................. 3 2. Installation...................................

This integrated access device combines Internet gateway functions with wireless LAN and Fast Ethernet switch. Designed for the business and home, it saves you the cost of installing a separate modem and ISP line for each computer, while providing ready connection for the users, with or without network cables. Broadband network access is also gaining ground. However, allowing more than two computers to access the Internet at the same time means higher costs. Thus, there is a need to share one leg