Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk

Repeat mode indicator I. Message file name J. Message folder name Built-in Memory SD Card Built-in L microphone Built-in R microphone Play/Stop Record indicator L Peak indicator R Peak indicator Record/Stop LCD display UP SD socket DOWN MODE ERASE / PAUSE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 DIGITAL VOICE RECORDER MODEL:PPR80 INSTRUCTION MANUAL External MIC Jack Battery compartment E. Volume Level indicator A. Stereo/Mono mode indicator C. 24bit/16bit indicator B. Sampl

Be sure the device is ON. Using the Microphone Incorporating Voice into the Mix To blend voice from the microphones with the audio program material, first be sure the MIC/TALKOVER switch is set to the ON position. (In this position, the MIC channel is mixed into the program like any other audio input source.) Then adjust the corresponding MIC level controls to increase or decrease the microphone level (this will not affect the main volume inputs). When a microphone is not in use, set the MIC

LED lights to indicate kill is activated. Channel Gain Control Lets you adjust the gain of the input source Channel Input Selector Lets you choose the input source to play for each channel Channel CUE Switch Allows you to monitor the selected audio input source and prepare it prior to mixing it in. Dual Display Meter Indicates the levels of Left and Right Master Channels 10-Band Equalizer Allows you to tailor the mixer output to suit your taste or performance environment. Each frequency ran

Please note that Phone 1 and Line 1 (as well as Phono 2 and Line 3) use the same jacks. The selector switch below the jacks should be set to Phono position if the jacks are used for phono inputs. When using a turntable, you should also securely connect its ground wire (usually green or black) to the Ground screw on the input panel of the mixer. NOTE! If you use a Turntable in the Phonol/Linel (and/or Phono2/Une3) input jack(s), be sure to place the Input Select switch in the PHONOl (and/or PH

and either play the signal from it or play another input through it. Headphone Level Control Headphone Jack Accepts headphones with 1/4" plug Headphone CUE/PGM Control Allows you to listen simultaneously or separately to the CUE material or the active program ECHO Delay Control Lets you adjust the delay time for the echo ECHO Repeat Control Lets you control the time period during which the echo is repeated ECHO Level Control Controls the depth of the echo effect ECHO On/Off Switch Sound

Units purchased in the USA are warranted to be free of defects in material and workmanship for two (2) years from the date of purchase. This warranty is limited to the original retail purchaser of the mixer. Should the unit fail due to factory defects in material or workmanship, your unit will be repaired or replaced at the sole discretion of PYLE. To obtain warranty service, you must first call our Consumer Return Hotline at (718) 236-6948 to obtain a Return Authorization Number. This R.A. #

In order to be able to make the best use of this device, please read the instruction manual carefully. Do not discard keep the manual for future reference Wear the Heart Rate Belt on your chest with the sensor over your heart for detection of the heart rate. 2? You will notice that there are two noticeably different patches on the inside of the Heart Rate Belt. These are the sensors for detecting your Heart Rate. Before you put the Heart Rate Belt, wet these two patches lightly so that t

Before using this apparatus, read the operating guide for further warnings. 2. Power Sources- The unit should be connected to a power supply only of the type described in the operation instructions or as marked on the unit ATTENTION: The power cord of the unit should be unplugged from the outlet when left unused for a long period of time. FEATURES: 15" Subwoofer Enclosure with built-in Amplifier Module Heavy Duty MDF Construction Two 8" High Efficiency 2-Way Speakers 8" Midrange Driver 1"

. ............................................................................................ . .............................................................. ............................................................................................ . ............................................................................................ . ............................................................................................ . ................................ ......................