Il doit etre utilise en position verticale. Si pour une raison quelconque vous deviez le coucher sur le cote, ne le remettez en route que deux heures environ apres l'avoir replace en position verticale. Ceci permettra le repositionnement correct des liquides et gaz du systeme refrigerant. INSTRUCTIONS DE SECURITE A lire attentivement avant utilisation Securite • Ne pas arreter l'appareil en debranchant la prise de courant en cours de fonctionnement. Ceci pourrait endommager le circuit de control

Push right side of connector flange into right side of vent opening. Adjust connector flange slightly so it is square in the opening. The foam gaskets will rest between the connector and the edge of the vent opening. 5. Push nozzle onto small connector end of vent duct pipe. 6. Place nozzle out an open window or through an exterior wall. Contact an experienced contractor or qualified craftsman to modify wall or windows, if necessary. To use the Exhaust Duct Kit with other Freecom accessories, fo

Place unit in its upright position for a minimum of three hours before operating for the first time. 1. 2. 3. 4. Place unit on a solid, level surface. Operating this unit on uneven or soft surfaces may cause vibration, noise, and possible water leakage from the condensate tank. Place unit at least 20" from any walls, draperies, or other obstructions. Carefully push the unit on its caster wheels to desired location. CAUTION: Do not operate unit without condensate water tank and air filters proper

0A9471 (Revised 11/97) TABLE OF CONTENTS Owner's Record ............................................................................................................2 Features ........................................................................................................................3 Accessories ..................................................................................................................3 Important Safety Information ..............................................

Before installing the drive, please read through the following points regarding its compatibility with your system. Freecom Technologies • Germany Warning ! All rights reserved. The products named in this manual are only used for identification purposes and may be trademarks or registered trademarks of the respective companies. This device was designed for home or office use. Warning! This device is equipment complying with EN55022 class B. Freecom cannot be made liable for any damages, loss of

Use only a solvent-free, non-abrasive marker when writing on a CD/DVD. • Do not stick any conventional labels on the CD-Rs/CD-RWs, since the adhesive can attack the medium. Special labels for CD-R/CD-RW media are available in retail computer stores. Never remove a label from a CD-R/CD-RW media otherwise you will damage the protective layer and make the CD-R/CD-RW unusable. • The drive recognizes the medium as soon as it is placed into the drive. CD-R media are compatible with the vast majority o

3. Connect the interface cable to the interface port of your computer. Since USB .0is backwards compatible with USB 1.1, the Freecom Mobile DVD RW Recorder can be connected to all USB ports. When connected to a USB 1.1 port, however, the performance (data transfer rate) of the Freecom Mobile DVD RW Recorder will be much lower than when the drive is connected to a USB .0 port. 6 EN 1 Start Up Note: You can plug the USB cable into your computer and unplug it while the computer is running ("hot plu

1.4 Allocation of the drive letter to the Freecom drive (PC) After successfully completing the installation of the Freecom drive a new drive letter is assigned automatically. This can shift the drive letter of an internal drive (for example, 'D' to 'E'). If this leads to problems, it is possible to change the drive letter assignment as follows: 1. Click on the „Start“/“Windows“ button. 2. Right-click on „Computer“ and select „Manage“ – „Disk Management“. 3. Right-click on the drive whose drive l

DVD recording is not reliable through USB 1.1. 4 General information General information Media standards • BD-ROM, BD-RE, BD-R, DVD-ROM, DVD±R, DVD±RW, DVD-RAM, CD-ROM, CD-ROM XA, CD-I, Photo-CD, Video CD, CD-Extra, CD-Text, CD-R, CD-RW Precautionary Measures and General Notes EN • After transport, particularly at low outside temperatures, condensation can form which can lead to a malfunctioning. For that reason, you should not begin operation until the drive and CDs/DVDs/BDs have reached room t

• Never place air conditioner near flammable materials. • Never put heavy objects on the unit. • To avoid damage and maintain proper operation, place indoor unit a minimum of 30 inches from curtains, furniture, blankets, loose material, or any other obstructions. Keep the unit a safe distance from stairs. • DO NOT use or operate the product in a confined space, such as a closet. • To avoid water leakage and damage: • Always operate the product on a solid, level surface. • Before moving the unit,