Log:

IDEAL INDUSTRIES MINI HE C24

Scaricare : 4 File Size : 188 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

The appliance operation light A will flash every 4 seconds. For long periods When you do not expect to use the boiler for a long period: 1 Switch the electricity supply off. 2 Shut off the gas supply cock and the valves for the water circuits fitted under the boiler. 3 If necessary, empty the water circuits. FROST PROTECTION This appliance is provided with a built in anti---freeze system that operates the boiler when the temperature is below 5 uC Therefore, when the boiler is not lit and used in

IDEAL INDUSTRIES MINI HE C28

Scaricare : 48 File Size : 188 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

appliance No. 47- ---348- ---38 mini HE C28 G.C. appliance No. 47- ---348- ---39 Destination countries: GB, IE INTRODUCTION mini HE are wall mounted, room sealed, condensing, low water content combination gas boilers featuring full sequence automatic spark ignition and fan assisted combustion. SAFETY Current Gas Safety (Installation & Use) Regulationsorrules in force In your own interest, and thatof safety, it is the law that this boiler must be installed by a CORGI registered installer or in IE

IDEAL INDUSTRIES MINI C24

Scaricare : 17 File Size : 195 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

Check that the system water water pressure gauge G reads at least 0,5 bar. Check the lock---out signal lamp E. If it is illuminated press the boiler reset button D to restart the ignition sequence. Hot water but no heating Check that the programmer and room thermostat (if fitted) are both calling for heat. Heating but no hot water Check that cold water flows out of the taps at a minimum rate of 3.5 litres per minute (or 1 pint in 10 seconds or less). If not, look for stop valves not fully open.

IDEAL INDUSTRIES MINI C32

Scaricare : 3 File Size : 195 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

· Check the room thermostat is set at the required temperature – Test the room thermostat by turning fully up – If this does not respond contact your installer · Check the radiator temperature control (C) is set at the winter setting for central heating. The nature of all combination boilers is to heat up water directly from the incoming mains water supply directly through the boiler to supply domestic hot water at the stated flow rates, (as shown in the boiler installation instructions), to ach

IDEAL INDUSTRIES MINI S28

Scaricare : 1 File Size : 195 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

F If the boiler is installed in a compartment then the compartment MUST NOT be used for storage purposes. F Under no circumstances should any of the sealed components on this appliance be used incorrectly or tampered with. F If it is known or suspected that a fault exist on the boiler then it MUST NOT BE USED until the fault has been corrected by a CORGI registered installer or in IE a competent person. MINIMUM CLEARANCES Clearances of 200 mm (7 7/8“) above and below, 25 mm (1“) at left, 50 mm (

IDEAL INDUSTRIES MINI S24

Scaricare : 0 File Size : 195 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers (button) Mini BOILER CONTROLS Mini C24 G.C. appliance No. 47- ---348- ---18 Mini C28 G.C. appliance No. 47- --- 348- --- 19 Mini C32 G.C. appliance No. 47- --- 348- --- 25A Mini S24 G.C. appliance No. 41- --- 392- --- 98 Mini S28 G.C. appliance No. 41- --- 392- --- 99 Destination countries: GB, IE INTRODUCTION Mini are wall mounted, room sealed, non condensing boilers featuring full sequence automatic s

IDEAL INDUSTRIES MINI C28

Scaricare : 4 File Size : 195 kb    Produttore : IDEAL INDUSTRIES  
Categoria : scaldabagno

Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. THE LOG BOOK SHOULD BE COMPLETED AFTER EACH SERVICE AND KEPT WITH THESE INSTRUCTIONS (button) CONTROL OF CH TEMPERATURE The output temperature of CH water is adjustable from a minimum of about 38°C to a maximum of about 85°C by turning the knob C. Approx CH flow temperat

IDEAL INDUSTRIES Heat Gun

Scaricare : 5 File Size : 515 kb    Produttore : IDEAL INDUSTRIES  
Categoria : asciugatrici costruzione

Becker Place Sycamore, IL 60178, U.S.A. 800-435-0705 Customer Assistance idealindustries.com ND 4481-1 DOUBLE INSULATED Danger! When working with heat guns it is vital to follow the following preventive safety guidelines to avoid the risk of fire, explosion, electric shock and bodily injuries. Read these instructions attentively before you use the tool. Keep these instructions in a safe place. SAFETY INSTRUCTIONSUSA Warning • Danger! Unplug the tool before opening it, as live components and conn

IDEAL INDUSTRIES IDEAL 2401

Scaricare : 8 File Size : 710 kb    Produttore : IDEAL INDUSTRIES  
Categoria : Trituratori

115 V / 15A min. D Freier Zugang zum Netzanschlu. GB Ensure free access to mains F Menager un acces libre a la prise de courant NL Zorg voor een vrije toegang bij het stopcontact I Assicurare libero accesso all.energia elettrica E Asegurese de tener libre acceso al enchufe principal S Se till att natanslutningen inte ar blockerad - 4 • Sicherheitshinweise • Safety precautions • • Consignes de securite • Veiligheidsvoorschriften • • Misure di Sicurezza • Normas de Seguridad • • Sakerhetsforeskrif

IDEAL INDUSTRIES 2350-Micro/Cut

Scaricare : 0 File Size : 710 kb    Produttore : IDEAL INDUSTRIES  
Categoria : Trituratori

GB Please read these operating instructions before putting the machine into operation and observe the safety precautions. F Nous vous prions de lire attentivement le mode d’emploi avant d’utiliser la machine, et attirons votre attention sur les consignes de securite. NL Leest u voor de ingebruik name van het apparaat a.u.b. deze gebruiksaanwijzing goed door en neemt u de veiligheidsinstructies in acht. I Per favore legga questo manuale di istruzione prima di mettere in funzione il distruggidocum





categorie