Find the appropriate wires to the PC board and remove the wires from the board. 6. Pull the probe wire through the wiring harness. 7. Install new probe in reverse order. 2-11. FRIGIPROBE 1. Remove the electrical power to the unit. Air Probe Evaporator Probe Frigiprobe To avoid electrical shock or property damage, move the power switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle. 2. Using a Phillips head screwdriver, remove the two screws securing the evaporator

INTRODUCTION This section provides procedures for the checkout and replacement of the various parts used within the blast chiller/freezer. Before replacing any parts, refer to the Troubleshooting Section. It will aid you in determining the cause of the malfunction. 2-2. MAINTENANCE HINTS 1. You may want to use a multimeter to check the electric components. 2. When the manual refers to the circuit being closed, the multimeter should read zero unless otherwise noted. 3. When the manual refers to t

OPERATING CONTROLS Item Description Function 1 Main Power Switch with Built- In Indicator Lights A three way rocker switch with a center off position. Pressing the left side of the rocker switch (COOK position) operates the fryer, and the amber light illuminates. No light is visible when the switch is in the OFF position. To filter, press the right side of the rocker switch (PUMP position) to operate the pump motor, and the red light illuminates. 2 Single Stage Thermostat An electromechanical de

- SCR-8 8 - 7 03605 BASKET - COATED - SCR-8 8 - 7 03473 BASKET - STD. - SCR-6 -6 7 03604 BASKET - COATED - SCR-6 -6 7 43804* SOLID BOTTOM BASKET ASSY. - SCR-6 -6 7 43805* SOLID BOTTOM BASKET ASSY. - SCR-8 8 - 7 43813* GRID - SOLID BASKET - SCR-6 -6 7 43815* GRID - SOLID BASKET - SCR-8 8 - 7 03504* BASKET-SCR8 COATED CHICKEN (W ALMART) 7 - 7 03503* BASKET-SCR8 UN-COATED CHICKEN (W ALMART) 7 - 7 03509* BASKET - SCR8 - BUTTERFL Y 8 - 7 03511* BASKET - SCR6 - BUTTERFL Y -6 8 03524 STIXSTAND SKEWER -

factory, Eaton, Ohio, or F.O.B. authorized distributor. Baskets will be repaired or replaced for ninety (90) days from date of original installation. Lamps and fuses are not covered under this Limited Warranty. To validate this warranty, the registration card for the appliance must be mailed to Henny Penny within ten (10) days after installation. FILTER SYSTEM: Failure of any parts within a fryer filter system caused by the use of the non-OEM filters or other unapproved filters is not covered un

203 4-1 air temperature probe concentration ring assembly clean water pan setpoint control panel deliming agent drain valve float switch food probe food probe receptacle humidity sensor humidity setting LED minimum holding temperature module out of water trip point parameters power switch pressure sprayer Model HCS-2/HCW-3/HCW-5/HCW-8 G L O S S A R Y HENNY PENNY HOLDING CABINETS a round device located inside the cabinet that measures the inside air temperature and sends that information to the c

The panel will fall into your hand. See photo at left. 2. Remove the light bulb. 3. Replace the light bulb with a Westinghouse #60A19/35, 130 Volt bulb. If this bulb is not available, a standard 60 watt bulb will work until a long life bulb can be obtained. 4. Replace the glass panel. 2-6 103 Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS Model HCS-2 Model HCW-3 1006 2-7 Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) Model HCW-5 2-8 1006 Model HCS-2/HCW-3/HCW-5/HCW-8

SAFETYALERT SYMBOL is used with DANGER, WARNING, or CAUTION which indicates a personal injury type hazard. NOTICE is used to highlight especially important information. CAUTION used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. The word WARNING is used to alert you to a procedure, that if not perform

OPERATING CONTROLS (Continued) Fig. No. Item No. Description Function 3-10 13 Water Control Switch A three-position switch with center position being OFF; in the position marked AUTOMATIC (up), the water level in the unit will be controlled by the float switch; in the position marked MANUAL (down), the water valve is opened directly by the switch; the MANUAL position is spring loaded so that the water valve will close when the switch is released 3-10 14 Water Light A light operated directly by t

2-1 2-2. Unpacking........................................................................................................... 2-1 2-3. Location.............................................................................................................. 2-3 2-4. Remove Control End Panel.................................................................................. 2-3 2-5. Drain Connection ................................................................................................ 2-4 2-6