Ensure that they snap into place. See Figure 24. • Adjust the seat belt to be snug around the child’s waist. • Be sure that the BOTH of the child’s feet are fully on the platform at all times. • Be sure that BOTH of the child’s hands are holding the handles on the frame. Figure 23 Figure 24 ! WARNING NEVER allow a rear seated child to use the canopy as a hand hold. Caboose Ultralight Instruction Manual Page 10 Using the Stroller as an InfantCar Seat Carrier • To use the stroller to carry an infa

• Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5 slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have engaged securely and the hubcap cannot be pulled off. Figure 4 Installing the Front Wheels • Take one of the double wheel sets and locate the small hole in the rotating bracket that is inside the red lever. • Push the front axle into this hole and keep pushing the wheel set onto this axle until you hear an audible click. See Figure 5.

Keep these instructions for future reference. • Failure to follow these instructions could result in serious injury or death. • Never leave child unattended. • Avoid serious injury from falling or sliding out. • Always use safety belts and ensure that all children are positioned according to these instructions. • Keep all small parts out of the reach of children while assembling the stroller. • Be certain that the stroller is fully opened, the safety latch is in position, and the wheel brakes ar

For a younger child, the shoulder straps should be positioned through the lower sewn-in loops on the seatback. For a young child that is tall, the shoulder straps may be positioned through the upper sewn-in loops on the seatback. For a taller child, use the shoulder straps WITHOUT positioning them through these sewn-in loops. To re-position the shoulder straps, unbuckle them from the harness buckle and feed these straps through the sewn-in loops, insuring that they are not twisted. Re-buckle the