Stop switch/OIL GARD® light (if equipped) 9. Fuel fill 1 2 3 4 5 6 8 7 10. Fuel tank 11. Oil fill/Dipstick (if equipped) 12. Blower housing 13. Oil drain plug 13 11 12 10 14 16 9 15 14. Oil fill cap 15. Engine Model Type Code xxxxx xxxx xx xxxxxxxx 16. Muffler/(Muffler guard, if equipped)/ (Spark arrester, if equipped) GENERAL INFORMATION ENGINE MODEL This is a single cylinder, overhead valve (OHV), air-cooled engine. It is a low emissions engine. In the state of California, OHV Model Series 110

Maintenance Use only original equipment replacement parts. Other parts may not perform as well, may damage the unit, and may result in injury. In addition, use of other parts may void your warranty. We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. NOTICE: All the components used to build this engine must remain in place for proper operation. Emissions Control Maintenance, replacement, or repair of the emissions cont

How To Change The Gear Reduction Oil -Figure 16 If your engine is equipped with a gear reduction unit, service as follows. 1. Remove the oil fill plug (B) and the oil level plug (C). 2. Remove the oil drain plug (A, Figure 16) and drain the oil into an appropriate receptacle. 3. Install and tighten the oil drain plug. 4. To refill, slowly pour gear lube into the oil fill hole (see Specifications section). Continue to pour until the oil runs out of the oil level hole. 5. Install and tighten the o

6) See also Repair and Maintenance Safety on page 4 of this manual. 7) All replacement parts must meet manufacturer’s specifications. Page 9 PARTS BREAKDOWN FOR LS401221, LS401216, LS401213 AND LS401224 LOG SPLITTERS NUMBE PARTS BREAKDOWN FOR LS401221, LS401216, LS401213 AND LS401224 LOG SPLITTERS NUMBER NO. PART NO. DESCRIPTION REQUIRED LS401224 34 Ton Vertical/Horizontal Log Splitter Complete LS401213 28 Ton Vertical/Horizontal Log Splitter Complete LS401216 25 Ton Vertical/Horizontal Log Spli

• Start and run engine outdoors. • Do not start or run engine in enclosed area, even if doors or windows are open. CAUTION: This engine was shipped from Briggs & Stratton without oil. Before you start the engine, make sure you add oil according to the instructions in this manual. If you start the engine without oil, it will be damaged beyond repair and will not be covered under warranty. Determine The Starting System Before starting the engine, you must determine the type of starting system that

MS-5682-9/03 PRINTED IN U.S.A. Fig. 1 MOTOR COMPONENTS Support / Front handle Shift lever Oil fill cap / Dipstick Starter pull handle Safety / Engine stop switch Choke knob Fuel connector Throttle Mounting clamps Propeller Anti-ventilation plate Drive shaft housing Engine oil drain plug Carrying handle Muffler guard Transom brackets Spray plate Vent plug Gear case Gear case drain / Fill plug Serial number label Fig. 2 FUEL COMPONENTS Fuel filter Fuel pump Transport valve Fuel fill Fuel

[1] Place engine level and clean around oil fill area. [2] Remove oil fill cap or dipstick. Low Oil Fill OIL LEVEL [3] Pour oil slowly. Fill to point of overflowing. [4] Replace and tighten oil fill cap. OIL CHECKING AND ADDING OIL Low Oil Fill with Dipstick [1] Remove dipstick and wipe with clean cloth. [2] FULL OIL LEVEL Insert dipstick, but DO NOT TIGHTEN. Remove and check oil level. [3] Pour oil slowly. Fill to FULL mark on dipstick. Replace and tighten dipstick. FUEL TYPE OF FUEL TO USE • U

Change oil every 50 hours thereafter. If you are using your generator under extremely dirty or dusty conditions, or in extremely hot weather, change the oil more often. A CAUTION Avoid prolonged or repeated skin contact with used motor oil._ • Used motor oil has been shown to cause skin cancer in certain laboratory animals. • Thoroughly wash exposed areas with soap and water. KEEP OUT OF REACH OF CHILDREN. DON’T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS. Change the

LS401221 Owner’s Manual ASSEMBLY & OPERATING INSTRUCTIONS MODEL NO. LS401213 MODEL NO. LS401224 28 TON 34 TON This safety alert symbol identifies important safety messages in this manual. Failure to follow this important safety information may result in serious injury or death. LS50-634-905 Table of Contents Page(s) Important Safety Information................................................................................................................. 1-6 Intended Use .......................

SpeedClean™ es una marca registrada de Briggs & Stratton Power Products. BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC JEFFERSON,WISCONSIN, U.S.A. Model No. 020261-1 (2200 PSI Pressure Washer) Manual No. 198968B Revision - (04/21/2006) SpeedClean™ 2200 PSI Pressure Washer EXPLODED VIEW AND PARTS LIST — MAIN UNIT -10 ■ 19 — 9 Item Part # Description I I99643GS ASSY, Base 2 BI99780GS HANDLE 3 I99645GS ASSY, Chem Tank w/Clips I95964GS Clip I92980GS Kit, Fuel Valve 4 I96006GS HOS