If the dryer is moved to a new location, have it checked and reinstalled by a qualified service person. • To prevent personal injury or damage to the dryer, the electrical power cord of a gas dryer must be plugged into a properly grounded and polarized 3-prong outlet. The third grounding prong must never be removed. Never ground the dryer to a gas pipe. Do not use an extension cord or an adaptor plug. • ALWAYS disconnect the dryer from the electrical supply before attempting any service or clean

9-11 Pre-installation Requirements ................................................2 Reversing door ....................................................................12 Installation Requirements ..................................................3-7 Accessories/Replacement parts ............................................12 Installed Dimensions .............................................................8 Espanol ...............................................................................1

• When drying large items, dry only two or three items at a time. Fill out the load with small and medium sized items. • For delicate or very small loads, add two or three similar items to improve tumbling action. 4. Select the appropriate cycle and settings for each load. • See Operating Instructions for your specifi c model. 5. Start the cycle. • To add or remove items when the dryer is running, open the door. The dryer will stop when the door is opened. Allow the drum to come to a complete st

Kit is available from an authorized parts distributor. 0” 0”1”0” (0 cm) (0 cm) (2.5 cm) (0 cm) 0” (0 cm) REAR CONSOLE MINIMUM INSTALLATION CLEARANCES - Inches (cm) SIDES REAR TOP FRONT Alcove 0” (0 cm) 0” (0 cm) 16” (40.5 cm) n/a UnderCounter n/a n/a n/a n/a Closet 0” (0 cm) 0” (0 cm) 16” (40.5 cm) 1” (2.5 cm) 0” 0”1” 0” (0 cm) (0 cm) (2.5 cm) (0 cm) 16” (40.5 cm) 7 Front Console Dimensions Rear Console Dimensions electrical supply on rear of unit, power cord length on gas unit 1” (2.5 cm) 13 1/

e grgrounding prounding prong.ong. To reduce the risk of fi re, electrical shock, or injury to persons when using this dryer, comply with the basic warnings listed below. Failure to comply with these warnings could result in serious personal injuries. You can be killed or seriously injured if you don’t follow these Important Safety Instructions: PREVENT FIRE • Do not dry items that have been previously cleaned in, soaked in, or spotted with gasoline, cleaning solvents, kerosene, waxes, etc. Do n

The settings can be changed before the cycle is started. If changes are attempted after the cycle starts, the lights will blink, the signal will beep and “Err” will be displayed. Drying Temperature To change the preset temperature, press the Temperature button to scroll to the desired setting. To protect your fabrics, not all temperatures are available with every cycle. The temperature selected for the cycle will be remembered and recalled each time that cycle is selected in the future. To retur

In some installations there may be some sounds associated with air movement throughout the dryer, including the air duct, blower, and exhaust system. This is normal and can vary with load size and type. C. GAS VALVE (Gas models only.) The flow of gas is controlled by electric solenoids. During operation there may be a clicking sound as the valve opens and closes to control the gas flow. D. GAS BURNER (Gas models only.) When the burner is operating, there may be sounds generated as the air flow m

The indicator for that cycle will be illuminated. Follow the fabric care label instructions on items to be dried. For best results To change the cycle once it has begun, press the cancel button before selecting a new cycle. Just turning the cycle selector knob to another selection will not change the cycle. If the selection is changed after the cycle starts, the indicator lights will blink, the signal will beep and “Err” will be displayed. The signal will beep and the status lights will flash, b

2-4 Avoid Service checklist ..........................................................8 Drying Procedures .................................................................4 Warranty ..............................................................................9 Operating Instructions ...........................................................5 Espanol ...............................................................................10 Features .......................................................

• Remove items immediately. Hang or fold. • Do not overload dryer. • Remove items as soon as cycle ends. 7 Avoid Service Checklist Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this dryer. OCCURRENCE POSSIBLE CAUSE SOLUTION Dryer does not start. Electrical power cord is not securely plugged in or plug Make sure the plug fi ts tightly in wall outlet. may be loos