This symbol indicates the display is blinking. Measuring vertical separation (height between 2 points) 1st target point 2nd target point Rangefinder (eyes) Internal display Display when the vertical separation (height between two points) mode is selected. First target priority mode. Power turns off automatically after 30 seconds without operation. Aiming at the 1st point. Display of the height from horizontal level of 1st point. POWER button Push Measurement Result is stored until next measureme
IMPORTANT: Operation in Manual Mode re" quires the turntable connection to Remote Control only. The Turntable Sync Cable should be disconnected from the jack “M” on the control panel. To shoot in Manual Mode proceed as follows: 1. Switch on the turntable by pressing the red ON/OFF (I/O) button on the power panel. Figure 10.1 2. Choose «М» mode by pressing the «Mode» button. Figure 10.2 M10. ANUAL MODE M10. ANUAL MODE 3. Choose the required quantity of frames (8, 16, 32) by pressing the «Frame» b
Anything3D Corp assumes no responsibility or liability for any errors or inaccuracies that may appear in this book. © 2000"2001 Anything3D Corp. All right reserved. CONTENS 1. Safety instructions .................................................. 2 2. Introduction ............................................................ 6 3. Complete set of equipment .................................... 10 4. Description........................................................... 12 5. Installation ..........