= If chemical products or mixtures of product come into contact with the eyes or are swallowed consult a doctor immediately, taking the label of the product with you. = Wash all clothes that come into contact with the chemical, whether diluted or undiluted, thoroughly before using them again. = Don’t smoke, drink or eat when preparing or spraying the mix or near or in the fields treated. = DON’T ENTER THE TANK: the residues of a chemical product can cause poisoning and suffocation. = When sprayi

= Check the proper tyres inflation (pressure are indicated on tyres) 4.3 TRANSPORTING AND MOVING THE MACHINE Every time you have to lift the machine, before starting the operation, always make sure the lifting gear and the relevant tools and equipment (cables, hooks, etc..) are suitable for lifting the load and check the stability of the same. It is forbidden to unhook and move the machine with the tank full. The dry weight of the machine at the maximum level of fitting and with all the accessor

= connect hose T to deviator D using the union hose adaptor supplied. = turn the lever of deviator D to the filling position. = place the other end of the hose, on which you fitted filter G, in the watering point. = start the power-takeoff leaving pressure regulator C in the draining position (you don’t have to put the pump under pressure). = the filling speed in litres/minute is equal to the delivery of pump P. = visually check the level of the liquid in the tank and after filling stop the pump

It is used as follows: - turn pressure on in TOP-MIX premixer (see paragraph above) -turn lever 6 down and suck the product up. -the product is suctioned, mixed with water under pressure, and directly incorporated in the tank of the machine. -after incorporating the product in the tank, lift lever 6 back to a horizontal position. NOTE:To wash the incorporator, put it in the premixer for a few seconds, performing the hopper washing operations described in paragraph 4.4. 18 unigreen 4.13 WASHING T

4 1.2 GUARANTEE ....................................................................................................................... 4 1.3 PRODUCT RESPONSIBILITY .............................................................................................. 4 1.4 WARNING SIGNS IN THE MANUAL AND ON THE MACHINE ............................................. 4 2 SAFETY REGULATIONS AND RESIDUAL RISKS .............................................. 5 2.1 INTENDED USE .................................

9 CIRCUIT DIAGRAM .............................................................................................. 16 TABLE 4-5 TABLES OF DELIVERY OF NOZZLES FOR HAND LANCES ...................... 17 TABLE 8 PROBLEMS, CAUSES AND SOLUTIONS .......................................................... 18 TABLE 7 TABLE OF PROGRAMMED MAINTENANCE .................................................... 18 TAB.10 ALLOWED FITTINGS .................................................................................

Nevertheless, we list summarily a number of instructions to observe: Petrol mixture motors (two stroke): respect the percentage of oil present in the petrol and avoid the motor losing revs if the liquid contained in the cistern unexpectedly finishes. Petrol and diesel motors with electric starters: check the level of efficiency of the battery and carry out normal maintenance. Before starting check that the command lever of the pressure adjustor (lever A page 10) is in the discharge position; sta

= loosen the hand wheel of maximum pressure valve B completely (anticlockwise). = open volumetric valve E completely. = start the pump by activating the power-takeoff of the tractor at 540rpm = open main control A (position “ON”), the manometer will be activated = open the drain tap on filter F slightly (only ERGO and REMO).. = close volumetric valve E completely. If the pressure rises over the maximum limit of the system, make sure maximum pressure valve B is open (see previous indications) = o

4 1.1 COMPOSITION OF THE MANUAL ...................................................................................... 4 1.2 GUARANTEE ....................................................................................................................... 4 1.3 PRODUCT RESPONSIBILITY ............................................................................................. 4 1.4 WARNING SIGNS IN THE MANUAL AND ON THE MACHINE............................................4 2 SAFETY REGULATIONS AND

: Depending on the season the vegetation may be more or less luxuriant; bear this in mind before starting the treatment. If the plants don’t have much foliage you should diminish the quantity of litres per hectare using lower pressures or closing one or more jets of the fan. 6.4 CALIBRATING CANNON ATOMISERS ( Tables on pages 31-33 ) Atomisers with a cannon blower group are mainly intended for treating forest trees or other tall plants that it is impossible to drive into with the sprayer (for exa