44110 Enodis Phone: (216) 481-4900 Fax: (216) 481-3782 Visit our web site at SE95018 Rev. 5 For your safety # DANGER Keep clear of pressure relief discharge. A Keep hands away from moving parts and pinch points. IMPORTANT Inspect unit daily for proper operation. Do not fill kettle above 'r— recommended level marked on outside of kettle. CAUTION Surfaces may be extremely hot! Use protective equipment. Do not lean on or place objects on kettle lip. éc h âi Wear protective equipm

May be replaced by tilt switch if unit is power tilt. 4. Steam Valve ............. .Manually controls the amount of steam entering the kettle. 5. Scraper Blades........... .Scrapes the side of the kettle and moves product away 6. Main Agitator Arm......... .Provides most of the product movement. 7. Temperature Probe ........ .Probe holds temperature sensors for controller. 8. Secondary Arm ........... .Provides reverse agitation and product lift in kettle. 9. Drain Cock .............. .Use

The unit should not be heating or cooling at this point. 5. Push (*) button on CAL 9900 to read set point temperature. (This is the desired product temperature). 6. To change set point temperature push and hold (*) button while pushing (A ) or (V ) button. New set point is determined when (*) button is released. 7. Add product to kettle. 8. Turn ACTIVE/BYPASS switch to “ACTIVE”. If the set point temperature is higher than the BYPASS ACTIVE product temperature, the kettle will start heating

Q. >- I- Q. • CONTINUE RESET OFF ON >- ; >-Ql cl NC in —I —I : ! > \ i— (N0) NC i û. A : ^ I LU ! 1—1 LI u n NC EMPTY EMPTY >- I- Q- LU L-l INTERRUPT START POWER Cleveland DIGITAL WATER METER OPERATING INSTRUCTIONS 1. Turn POWER switch ON. 2. Set required volume. Do not exceed kettle capacity. 3. Locate delivery spout over desired kettle. 4. Press START switch downward to RESET. Delivery will start at “0” and stop at preset volume. 5. To stop delivery an

PART NO. DESCRIPTION QTY. 1. FI05058 3/4" Cross ......................................................1 2. KE02055-2 Steam Valve Modification ..........................................2 3. N0640B4.5 Nipple .........................................................2 4. FI00063 Elbow 90 degree.................................................4 5. FI000356 Reducing Bushing................................................1 6. KE600812-1 Street Elbow ...............................................

We do however provide the following chart as a guide line for inspection and maintenance to keep your unit functioning at 100%. MONTHLY INSPECTIONS Item Inspection Item Switches Product Drain Valves Tangent Draw-Off Valve Butterfly Valve. Air Valve Inspect switches for damage and correct operation. Replace as required. Inspect parts for damage. Test valve for leakage. Replace as required. Inspect parts for damage. Test valve for leakage. Replace as required. Inspect parts for damage. Te

• Extended Warranty has the same exclusions as stated in our standard warranty. Cleveland Range, Inc. 1333 East 179th St., Cleveland Ohio, U.S.A. 44110 Ph: 1-216-481-4900 Fx: 1-216-481-3782 Visit our Web Site at II. SteamCub® Product Information Operating Controls Main Power ON/OFF Serial Number/Model Number Identification Drain Valve 6” (152mm) Stainless Steel Adjustable Legs with skid resistant flanged feet Drain Pan Guides Time/Temp. Display “Heat-On” Indicator Light Condensate Vent Removable

(Electronic Timer Models only). Timer transformer has failed. See note #1. Inoperative controls. See note #1. Steam flow does not stop when timer stops. Operating in manual mode. Switch to timed mode for timer to be effective. Heat Standby Switch has loosened or failed closed. (21CET16 only) See note #1. Heat standby timer is stuck closed. (21CET8 or 24CEA10 only) See note #1. Inoperative controls inside cabinet. Turn off electricity at main external power switch. See note #1. Steam and/or water

Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. WARNING Disconnect power before servicing IMPORTANT A QUALIFIED CLEVELAND RANGE TECHNICIAN MUST PERFORM ALL SERVICE. RETAIN THIS MANUAL FOR YOUR REFERENCE You may wish to record the following items for future use. Model Number _________________________ Serial Number __________________________ Date of Installation _______________________ OPERATOR’S MANUAL Table of Contents Chapt

C 5/07 FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. ELECTRIC SHOC